Slack adjusters: automaticRecall 03V-167 · Crane vehicles
CRANE CARRIER COMPANY recall 03V-167 covers 130 Crane vehicles for a slack adjusters: automatic problem, reported to NHTSA on May 1, 2003.
Source: NHTSA recall 03V167000 and manufacturer quarterly reports. Started by the manufacturer.
The problem
ON CERTAIN TRAILERS EQUIPPED WITH A SPECIFIC COMBINATION OF REYCO SUSPENSION, EATON DRIVE AXLE, AND BENDIX SLACK ADJUSTERS, THE FAILURE OF A DRIVE AXLE SLACK ADJUSTER TO AUTOMATICALLY ADJUST AS REQUIRED TO COMPENSATE FOR BRAKE WEAR, WILL CAUSE AN OUT OF ADJUSTMENT CONDITION. IF THIS CONDITION OCCURS AND IS NOT IDENTIFIED AND CORRECTED THROUGH NORMAL INSPECTIONS AND MAINTENANCE, THE SLACK ADJUSTER WILL OVER-ROTATE AND MAY CONTACT THE SUSPENSION LOWER SPRING SADDLE.
The risk
IF THIS OCCURS, BRAKING PERFORMANCE WILL BE INHIBITED, INCREASING THE RISK OF A CRASH WITHOUT WARNING.
The fix
CRANE CARRIER WILL SUPPLY, AT NO CHARGE, GUNITE SLACK ADJUSTERS AND INSTALLATION INSTRUCTIONS TO REPLACE THE EXISTING BENDIX SLACK ADJUSTERS ON THE DRIVE AXLE. THE INSTALLING FACILITY WILL BE REIMBURSED BY CRANE FOR ONE (1) HOUR LABOR PER VEHICLE AT THEIR POSTED LABOR RATE. OWNER NOTIFICATION BEGAN ON JUNE 10, 2003. OWNERS SHOULD CONTACT CRANE AT 1-918-832-7305.
CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
Recall repairs are free. Confirm whether this recall is open on your vehicle by entering its VIN at nhtsa.gov/recalls.
Vehicles in this recall
Built from June 16, 2000 to April 28, 2003. Not every vehicle in these model years is included; check by VIN.