Steering: steering wheel/handle barRecall 68V-015 · GMC vehicles

GENERAL MOTORS CORP. recall 68V-015 covers 331 GMC vehicles for a steering: steering wheel/handle bar problem, reported to NHTSA on February 27, 1968.

–
Vehicles repairedNo manufacturer report yet
Vehicles affected3312 models
ReportedFeb 27, 1968Owners notified Feb 22, 1968
Complaints since0Same system, after the recall

Source: NHTSA recall 68V015000 and manufacturer quarterly reports. Started by the manufacturer.

What's wrong

The problem

What to do

The fix

The remedy has not been described yet.

POSSIBILITY THE BOLT WHICH CLAMPS THE UPPER UNIVERSAL JOINT YOKE TO THE LOWER STEERING SHAFT MAY NOT HAVE BEEN PROPERLY TIGHTENED AND MAY HAVE BEEN THE WRONG TYPE AND COULD LOOSEN.A LOOSE CLAMP BOLT COULD FALL OUT AND ALLOW THE UPPERUNIVERSAL JOINT AND LOWER STEERING SHAFT TO BECOME DISCONNECTED, RE- SULTING IN LOSS OF STEERING CONTROL.(CORRECT BY REPLACING THE UPPER UNIVERSAL JOINT YOKE CLAMP BOLT.)

Recall repairs are free. Confirm whether this recall is open on your vehicle by entering its VIN at nhtsa.gov/recalls.

2 models

Vehicles in this recall